Notes, Examples – Synaccess Networks NP-0801DTM User Manual

Page 37

Advertising

HAYES COMPLIANT AT COMMANDS

HSPA+ AT Commands Reference Guide

  FD ‐ SIM fixed dialing‐phonebook
  LD ‐ SIM last‐dialing‐phonebook
  MC ‐ device missed (unanswered received) calls list
  RC ‐ ME received calls list
  MB ‐ mailbox numbers stored on SIM, if this service is provided by
the SIM. See #MBN.

<n>

‐ entry location; Ensure it is in the range of locations available in

the memory used.

ATD><n>[;]

Issues a call to phone number in entry location <n> of the active
phonebook memory storage. See +CPBS.
If “;” is present a voice call is performed.

<n>

‐ active phonebook memory storage entry location; it should be

in the range of locations available in the active phonebook memory
storage.

ATDL

Issues a call to the last number dialed.

ATDS=<nr>[;]

Issues a call to the number stored in the module internal
phonebook position number <nr>.
If “;” is present a voice call is performed.

<nr>

‐ internal phonebook position to be called. See commands &N

and &Z.

ATD<number>I[;]
ATD<number>i[;]

Issues a call overwriting the CLIR supplementary service
subscription default value for this call
If “;” is present a voice call is performed.
  I ‐ invocation, restrict CLI presentation
  i ‐ suppression, allow CLI presentation

ATD<number>G[;]
ATD<number>g[;]

Issues a call checking the CUG supplementary service information
for the current call. Refer to +CCUG command.
If “;” is present a voice call is performed.

ATD*<gprs_sc>
[*<addr>][*[<L2P>]
[*[<cid>]]]]#

This command is specific of GPRS function and causes the MT to
perform whatever actions are necessary to establish
communication between the TE and the external PDN.

<gprs_sc>

‐ GPRS Service Code, a digit string (value 99) that

identifies a request to use the GPRS

<addr>

‐ string that identifies the called party in the address space

applicable to the PDP.

<L2P>

‐ a string that indicates the layer 2 protocol. For

communications software that does not support arbitrary
characters in the dial string, the following numeric equivalents are
used:
1 ‐ PPP

<cid>

‐ Digit that specifies a particular PDP context definition. See

+CGDCONT.

Notes

Reference: V.25ter.

You can issue this command on a non voice device, however, the result is no carrier, because you are only able
to originate a voice call on data‐only devices.

Examples

To dial a number in SIM phonebook entry 6:

Advertising