Xtramus MCS-2160 V1.9.2 - Manual (Page 73)

3.3 Managing MCS-2160 with Telnet
3.3.1. Telnet Settings for MCS-2160
Before setting Telnet for MCS-2160, please activate this service on your PC.
Establishing Connection with MCS-2160
1. Please click Start button on your
desktop, than choose: Run…Ætype
CMDÆclick
OKÆtype telnet
192.168.1.8Æclick Enter, and you will
see the window on the left.
2. Type “admin” on the user name and
user password field to access the
MCS-2160 system.
*Note: If you change MCS-2160’s user name and password with MCS-2160’s configuration webpage, please log in
with the new user name and password here.
Please Note: If you log in the Telnet to access the MCS-2160 system, the previous accessed Web
Management will automatically log out from the MCS-2160 system.
3.2.2. MCS-2160 Telnet Commands
After logging in MCS-2160 via Telnet, a MCS-2160 Command Menu will be displayed, showing
MCS-2160’s Telnet commands. Please see the table down below for brief descriptions of MCS-2160
commands:
Command Alias Command Description
system sys
The system command allows you to view MCS-2160’s system information, make
system configurations, and upgrade MCS-2160’s firmware/FPGA.
ip ip
The ip command allows you to view MCS-2160’s current IP settings or configure
these settings.
cls cls The cls command allows you to clear HyperTerminal screen.
logout logout
The logout command allows you to log out. For security issues, it is
recommended that you should log out if you’re not using the HyperTerminal
anymore.
Please see sections down below for more detailed information regarding to MCS-2160’s command.
73
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®