Setting the slave address – BECKHOFF BC3150 User Manual
Page 28
Advertising
Safety Instructions
26
Fieldbus Components
Setting the slave address
The address must be set via the two rotary selection switches. The default setting is 11. All addresses are permitted,
although each address may only occur once within the network. For changing an address the Bus Coupler must be
switched off. The switches can be set to the required position using a screwdriver. Ensure that the switches engage
correctly. The lower switch is the 10-multiplier, the upper switch is the 1-multiplier. The change in address is active as
soon as the module is switched on.
Example
You want to set address 34:
•
lower rotary selection switch Sx11: 3
•
upper rotary selection switch Sx10: 4
Advertising