BECKHOFF BC3150 - Manual (Page 29)

Safety Instructions
Fieldbus Components 27
Configuration
Overview
Configuration types
DEFAULT-CONFIG
Bus Terminals are mapped in the order they are inserted, i.e. first the complex Bus Terminals followed by the digital
Bus Terminals.
The complex Bus Terminals are mapped as follows:
•
Word Alignment
•
complex representation
The fieldbus slave interface are the PLC variables. The PLC variables have addresses from %QB1000 and %IB1000.
TWINCAT-CONFIG
Bus Terminals and PLC variables can be linked freely in TWINCAT-CONFIG (TC-file required). The configuration is
transferred to the coupler via the System Manager and ADS.
The following is required for TwinCAT Config:
•
Via the fieldbus (PROFIBUS, CANopen, Ethernet)
PROFIBUS: (BC3150, BX3100)
- PC with FC310x from version 2.0 and TwinCAT 2.9 build 1000
- BX3100 with firmware from 0.28 with CIF60 or CP5412
- TwinCAT 2.9 build 946
(WARNING: only one ADS communication is permitted with the Hilscher cards, i.e. either System Manager
or PLC Control)
CANopen: (BC5150, BX5100)
PC with FC510x from version 1.76 or higher and TwinCAT 2.9 build 1030
DeviceNet: (BC5250, BX5200)
on request
Ethernet: (BX9000):
- TwinCAT 2.10 Build xxxx
•
Via serial ADS TwinCAT 2.9 build 1010 for NT4.0, 2000 or XP
- BX3100 version 1.00
- BX5100 version 1.00
- BX5200 version 1.10
- BX8000 version 1.00
- BC3150, BC5150, BC5250 Frimware B0
- BC8150 TwinCAT 2.10 Build 1244
The BX can be parameterised via the System Manager of the TwinCAT program.
•
Variable I/O mapping
•
Type-specific PROFIBUS data (only BC3150 or BX3100)
•
RTC (Real Time Clock) (only BX-controller)
•
SSB bus (Smart System Bus) (only BX-controller)
•
PLC settings
•
K-Bus settings
The configuration can be transferred to the BXxxxx or BCxx50 via fieldbus ADS protocol or with the serial ADS
protocol.