Program transmission, Transmission via the serial interface and ads, Transmission via serial interface – BECKHOFF BC3150 User Manual
Page 78
Safety Instructions
76
Fieldbus Components
Program Transmission
Transmission via Serial Interface
Every Bus Terminal Controller can be programmed via the PC's RS232 interface.
Select the serial interface in TwinCAT PLC Control.
The settings for the serial interface, port number, baud rate etc. are found under Online/Communication parameters
in PLC Control.
The Bus Terminal Controller requires the following setting:
•
Baud Rate: 9600/19200/38400/57600 baud (automatic baud rate detection)
•
Stop bits: 1
•
Parity: even
Transmission via the serial interface and ADS
The Bus Terminal Controller can be programmed via the PC's RS232 interface. Before it can be used, the TwinCAT
has to be made aware of the Bus Terminal Controller (see serial ADS).
Select the ADS connection in TwinCAT PLC Control.