Compuprint 2056 - Manual (Page 32)

User Manual 2056
MAN10xxx-01 24
2.4.2 In the Cut Sheet Mode
LF/FF
If the paper is at the print position in the offline mode, press the LF/FF key (less than 0.5
second), the printer would feed the paper one line based on the current line spacing setting.
Alternatively, hold the LF/FF key down, the printer would eject the paper until the cut sheet is
entirely ejected.
LOAD/EJECT
If the paper is at the print position in the offline mode, press the LOAD/EJECT key, the paper
would be entirely ejected from the printer.
ONLINE
If the printer has loaded paper in the offline mode, press the key to enter ONLINE mode, the
ONLINE
LED is on and the printer enters the print mode.
Press this key in the online mode, the printer is offline, ONLINE LED blinks and the printer
can not print.
2.4.3 Print Speed
The setting method of the print speed:
In offline mode, press the SPEED key to switch the print mode among Normal Speed mode,
High Speed mode and Super High Speed mode. The green LED denotes normal speed
mode, the yellow one denotes the high speed mode and the red one denotes the super high
speed mode.
2.4.4 Copy Setup Mode
Printer will turn on the Copy mode automatically when the gap adjust lever is set to 3 (or
higher).
In order to improve the copy definition when using multi-ply paper, you can select the copy
capability through the following steps:
1. In Online mode, long press SPEED key + TEAR key for about 3 seconds, after the printer
beeps three times, the PAPER OUT LED and ONLINE LED blink at the same time, and the
printer would present one beep every one or two seconds which indicates the printer has
entered Copy setup mode.
2. The SPEED LED indicates the current Copy setup mode:
Green denotes the quiet mode; Orange denotes the normal mode and Red denotes the
copy mode.
3. In Copy setup mode, press LF/FF key can switch the printer among quiet mode, normal
mode and copy mode.
4. After setting the Copy setup mode. Long press SPEED key + TEAR key for about 3
seconds, the printer beeps 3 times, which indicates the printer saves the setting and exits
the Copy setup mode.
5. You could also set Copy setup mode through driver or menu setup mode. (See details in
User's Manual)
2.4.5 Micro-Adjust of the Printing Home Position and the Tear Position
Operation steps of adjusting the printing home position: (the printing home position of cut
sheet is separated with that of the tractor paper. The following uses tractor paper as an
example)