Compuprint 2056 - Manual (Page 54)

User Manual 2056
MAN10xxx-01 46
 Tractor paper does not feed properly
Phenomenon 1: The tractor does not feed the paper.
Solutions:
1. Check that the paper select lever is pulled forward to the tractor paper position. If not,
move the lever to the correct position.
2. If this problem still can not be solved, the paper may peel off the tractor. Reattach the
paper to the tractor.
Phenomenon 2: Paper feeding is crooked or paper jam occurs
Solutions:
1. Make sure the location of the tractor paper do not block the feeding.
2. Make sure your paper is located within 1 meter (3 feet) from the printer.
3. Make sure the printer window is closed.
4. Make sure the tractors positions are correct. Position the right tractor at the triangular
guide marks.
5. Check that the holes on both sides of the paper are aligned with each other. Also, make
sure the tractors are locked and their covers are closed.
6. Check whether the paper specifications meet the standard request according to
Appendix A.
Phenomenon 3: The paper does not eject completely.
Solutions:
1. May be the page length is too long. When using the tractor, tear off the paper having
entered the printer, then press the LF/FF key to feed the paper forward. When using the
tractors, tear off the last printed paper, then press the LOAD/EJECT key to feed the
paper backward.
2. Please make sure the paper length is within specified range. (Refer to the paper
specifications in Appendix A)
Phenomenon 4: When you switch between cut sheet and tractor paper, printer beeps
some times and the ONLINE LED is off.
Solutions: There is paper left in the paper feed path while you change the paper select
lever position. Pull the paper select lever to the previous position and eject the
paper. Then change the paper select lever position again.
4.4 Alignment Adjust Mode
Enter the alignment adjust mode to improve the print quality when the printer has been
used for a long time.
Note: 1. When the gap adjust lever is in the position of 3 or above, the printer
enters copy mode automatically. Users can set the gap adjust lever
according to specific paper type (cut sheet or tractor paper), then adjust
the alignment as the steps below.
2. You must use the 80 columns tractor paper when adjusting alignment.