Compuprint 2056 User Manual
Page 37
User Manual 2056
MAN10xxx-01 29
5. Slide a piece of cut sheet down firmly between the right and left paper guides until it
meets resistance. The printer loads the sheet automatically. (Shown as below)
6. Adjust the printing home position according to the steps of Chapter Micro-Adjust of the
Printing Home Position and the Tear Position if necessary.
3.1.2 Loading Tractor Papers
For tractor paper, please refer to the following guide:
1. Make sure the printer is powered off, and open the window of the printer, refers to
chapter Gap Adjust Lever of this manual, pull the gad adjust lever to tractor paper
position according to the paper type.
Figure 3-5 Install cut
h t
Figure 3-6 Adjust the gap adjust lever
Note: Don’t feed the paper with paper feed knob, or it would influence the
consistency of paper-in position.