Compuprint 2056 - Manual (Page 38)

User Manual 2056
MAN10xxx-01 30
2. Close the window, and set paper select lever toward the tractor paper position.
3. Pull up the right handle of the tractor to loosen the right tractor. (Shown as below)
4. Slide the right paper guide referring to the scale on the printer. The printer can print to the
right of the scale 0. Push the right handle of the tractor to lock it in place. Then slide the
left paper guide to match the width of your paper, but do not lock it. Move the paper
support so it is midway between the tractors. (Shown as below)
5. Make sure the paper edge is clean and straight. Open the right and left tractor covers. Fit
the first holes of the paper over the tractors pins and then close the tractors covers. Slide
the left tractors to remove any slack from the paper and lock it in place (Shown as below).
Now the paper is in the ready position.
Figure 3-8 Loosen the right tractor
Figure 3-9 Adjust the distance between the right and left
Figure 3-7 Adjust the paper select lever
Right handle
Right tractor cover