Compuprint 2056 User Manual
Page 39
User Manual 2056
MAN10xxx-01 31
6. Make sure the printer window is closed. Turn on the printer, and press LOAD/EJECT key
to feed paper. You can adjust the printing home position according to chapter Micro-Adjust
of the Printing Home Position and the Tear Position. When the printer receives data, it
begins printing automatically.
7. When you finish printing (the printer receives no data for several seconds) the printer
feeds the perforation of the tractor paper to the edge of the printer cover so that you can
tear off easily.
8. If the perforation and the edge of the printer cover do not match, you should adjust the
tear off position following the steps in chapter Micro-Adjust of the Printing Home Position
and the Tear Position, after adjusting, tear down the paper. When the printer receives print
data, the paper automatically feeds back to the printing home position and begins to print.
How to switch tractor paper to cut sheet
Firstly, tear down the printed tractor paper, then hold LOAD/EJECT key down
continuously to eject the paper in the offline mode. Pull the paper select lever to the cut
sheet position, and load the cut sheet according to chapter Loading Cut Sheet.
Figure 3-10 Install the tractor paper on the tractors
Note: Do not use the paper feed knob to adjust the paper-in position due to the
micro-range is limited. When the adjustment exceeds the up-limit or
down-limit, the beeper beeps and the position can not be adjusted further.
The position is in effect before next adjustment. (The margin set in the
software can cover this adjustment, so you had better adjust the printing
home position with the software.)
Note: Set the auto tear off function ON in the Menu Setup Mode. Otherwise, the
printer does not feed the perforation to the edge of the printer cover.
Caution: Make sure the printed tractor paper is tore off before ejecting from the
printer, as too many pages ejected could cause paper jammed.
Note: Only when the printer is off and the jammed paper is removed, can the
paper feed knob on the right side of the printer be used. Otherwise, the
printer may be damaged and printing home position may be changed.