Compuprint 2056 User Manual
Page 40
User Manual 2056
MAN10xxx-01 32
3.1.3 Loading Multiply Papers
The installing ways of multi-ply papers and tractor paper are the same. Just pay attention to
the following tips:
1. Mus lift up the rear cover refer to the figure below, otherwise, it may cause paper jam
during printing.
2. Never load multi-ply papers joined by metal staples, tape, or continuous gluing.
3. Avoid printing beyond the printable area of multi-ply papers, or it may damage the print head (See
Appendix for details).
3.1.4 Loading Labels
The installing ways of label and tractor paper are the same. Keep these tips in mind:
1. Set the gap adjust lever to position “1”.
2. Make sure the printout stays entirely within the printable area or the print head may be
damaged. (See the Appendix for specifications.)
3. Labels are especially sensitive to temperature and humidity, so please use them only
under normal operating conditions.
4. Do not leave labels in the printer while doing other jobs, or they would curl around the
platen and cause paper jam when you resume printing.
5. Remove the labels from the printer, tear off the fresh supply at the rear of the printer; and
then press LF/FF key to advance the remaining labels out of the printer.
3.1.5 Loading Envelopes
The method of loading envelopes is generally the same with that of the cut sheet. Just pay
attention to the following tips:
1. Before loading an envelope, set the gap adjust lever to position 4 or 5.
2. Insert the envelope into the printer rear cover (as shown below), push it down gently until
it feeds into the printer.
Figure 3-11 Raise the rear cover
Caution: Never feed labels in and out through the printer; they can easily peel
off the mount and jam the printer. If a label does stick inside the
printer, contact your dealer.