Comtech EF Data CRS-200 REDUNDANCY SWITCH - Manual (Page 37)

CRS-200 COMTECH COMMUNICATIONS CORPORATION
CRS-200 REDUNDANCY SWITCH - OPERATIONS MANUAL PAGE 35
INFO: SWITCH-ID SETUP
IF-SWITCH REMCONT MASK
SWITCH ID:
THIS IS A TEST MESSAGE
TM: 1 2 3 4 5 - 7 - 9 10
AUTO:OFF BKUP:05 REST:20
TRANSPONDER SWITCH IS
ABSENT
REM CNTL: ON RS485-4W
ADDRESS: 5000 19200 BAUD
INFO (Information)
The user is prompted to select SWITCH-ID, SETUP, IF-SWITCH, REMCONT or MASK
using the
LEFT/RIGHT keys, then ENTER. These screens display information on the
current configuration of the switch without risking inadvertent alterations.
(INFO) SWITCH-ID
This displays the user-defined Switch ID string, which is entered via the
UTILITY, SWITCH-ID screen. To return to the previous menu, press
ENTER or CLEAR.
(INFO) SETUP
The information on this screen reflects some of the settings configured
in the CONFIG, OPTIONS menu. Active traffic modems are listed on
the top line, with Auto mode and the two holdoff times listed on the
bottom.
(INFO) IF-SWITCH
This screen shows whether a CRS-280 IF Transponder Switch is
connected to the CRS-200 1:N Redundancy Switch. When an IF switch
is present, the second line will indicate “PRESENT”, and any offline
modem (TM or RM) will not have its Transmit IF muted by the CRS-
200.
(INFO) REMCONT (Remote Control Info)
This screen shows if the unit is in LOCAL or REMOTE mode, and gives
details of the electrical interface type selected, the unit’s address, and
the baud rate selected. Pressing
ENTER takes the user back to the
previous menu.