Comtech EF Data CRS-200 REDUNDANCY SWITCH User Manual
Page 54
![background image](/files/778871/content/doc054.png)
Parameter
Command
Arguments for
Description of arguments
Response to Command
Query
Response to
Type
(Instruction
Command or
(note that all arguments are ASCII numeric codes, that is,
(target to controller)
(Instruction
query
Code and
Response to
ASCII codes between 48 and 57)
Code and
(target to
qualifier)
Query
qualifier)
controller)
CRS-200 REDUNDANCY SWITCH - OPERATIONS MANUAL
PAGE 52
Retrieve next 5
N/A
75 bytes
Query only
N/A
RNE?
RNE={CR}ABCd
unread Stored
Switch returns the oldest 5 Stored Events which have not
dmmyyhhmmss
Events
yet been read over the remote control. Reply format:
{CR}ABCddmm
{CR}Sub-body{CR}Sub-body{CR}Sub-body{CR}Sub-
yyhhmmss{CR}
body{CR}Sub-body, where Sub-body =
ABCddmmyyhh
ABCddmmyyhhmmss:
mmss{CR}ABCd
A being the fault/clear indicator, where:
dmmyyhhmmss
F = Fault, C = Clear, I = Info
{CR}ABCddmm
B being the fault type, where:
yyhhmmss
C = Switch Fault/Clear,
(see description
1,2,....A,B = Modem Fault/Clear (B = RM)
for details of
D = Power on/off, or log cleared (Info events)
arguments)
C being the fault code, where the value depends on fault
type:
Switch codes are 1 to D, defined the same as FLT string.
Modem codes are 1= Unit, 2= Rx traffic, 3= Tx traffic
Info codes are: 0= Power off, 1= Power on, 2= Log
cleared.
If there are no new events, the unit replies with RNE? If
fewer than 5 events remain, the last positions are zero
Retrieve
N/A
2 bytes,
Query only.
N/A
NUE?
NUE=xx (see
Number of
numerical
Switch returns the number of Stored Events which remain
description for
unread
unread, in the form xx. Note: This means unread over the
details of
Stored Events
remote control – viewing the stored events from the front
arguments)
panel of the modem does not affect this value. Example
reply: NUE=98
Local/Remote
LRS=
1 byte, value of
Command or query
LRS= (message ok)
LRS?
LRS=x (see
Status
0 or 1
Sets or queries the local/remote status of the switch:
LRS? (received ok, but
description for
0 = local
invalid arguments
details of
1= remote
found)
arguments)