Comtech EF Data CRS-200 REDUNDANCY SWITCH - Manual (Page 38)

CRS-200 COMTECH COMMUNICATIONS CORPORATION
CRS-200 REDUNDANCY SWITCH - OPERATIONS MANUAL PAGE 36
ALARMS MASKED: MODEM-TX
MODEM-RX
bbPSU-A PSU-B
``
MONITOR: STATUS SW-ALARM
STORED-EVENTS TM-CONFIGS
TM 02 IS BRIDGED BY RM
BACKUP HOLDOFF: 05 SEC
TM 02 IS BACKED UP BY RM
RESTORE HOLDOFF: OFF
STORED EVENTS: VIEW
CLEAR ALL (PRESS ENTER)
(INFO) MASK (Alarm Mask Info)
This screen shows which alarms are currently masked. If an alarm is not
masked, a blank is displayed in the relevant screen position. Power
Supplies A and B cannot be masked at the same time, but are shown
together here to indicate their relative positions.
MONITOR
The user is prompted to select STATUS, SW-ALARM, STORED EVENTS, or TM-
CONFIGS using the
LEFT/RIGHT arrow keys, then to press ENTER.
(MONITOR) STATUS
This screen shows the current status of the switch. When the redundant
modem is not backing up any of the traffic modems, the display will
show which TM is currently being bridged by the RM. If Auto mode is
on, it will also show the backup holdoff should the bridged TM fail. If
Auto mode is off, the second line displays “OFF”. When the switch has
taken the bridged TM offline and replaced it with the RM (whether
done manually or automatically), the screen changes as shown below:
Now, the restore holdoff will be shown on the second line if Auto
mode is on.
(MONITOR) STORED EVENTS
The user is prompted to select VIEW or CLEAR ALL, using the
LEFT/RIGHT arrow keys, then to press ENTER.