Comtech EF Data CRS-200 REDUNDANCY SWITCH - Manual (Page 55)

Parameter Command Arguments for Description of arguments Response to Command Query Response to
Type (Instruction Command or (note that all arguments are ASCII numeric codes, that is, (target to controller) (Instruction query
Code and Response to ASCII codes between 48 and 57) Code and (target to
qualifier) Query qualifier) controller)
CRS-200 REDUNDANCY SWITCH - OPERATIONS MANUAL PAGE 53
Serial Number SNO= 4 bytes Command portion is FACTORY USE ONLY. Used to set or SNO= (message ok) SNO? SNO=xxxx (see
numerical Query the units 4 digit serial number. SNO * (message ok, but description for
0000 to 9999 Unit returns its S/N, in the form xxxx. not permitted in current details of
Example: SNO=1765 mode arguments)
Software N/A 4 bytes, Query only. N/A SWR? SWR=x.xx (see
Revision numerical Unit returns the value of internal software revision installed description for
in the unit, in the form x.xx details of
Example: SWR=1.03 (Ver 1.03) arguments)
Equipment N/A 4 bytes, Query only. N/A EID? EID=xxxx (see
ID numerical Switch returns information concerning the equipment description for
identification, with only a base switch “S200” currently in details of
use arguments)
Faults N/A 13 bytes, Query only. Unit returns the current fault and status codes N/A FLT? FLT=xxxxxxxxx
and numerical for the switch itself, where each location in the string is xxxx (see
Status either 0 for no fault or 1 for faulted, and the positions are: description for
1 (leftmost) = RM remote comm problem details of
2/3 = +5v PSU-A under/over arguments
4/5 = +5v PSU-B under/over
6/7 = +12v PSU-A under/over
8/9 = +12v PSU-B under/over
10/11 = -12v PSU-A under/over
12/13 (rightmost) = -12v PSU-B under/over