Comtech EF Data SNM-1001 User Manual
Page 82
SNM-1001 Network Control Modem
Remote Control Operation
Rev. 1
A–23
Bulk Consol
Analog
Status
Command:
Response:
<add/BCAS_'cr'
>add/BCAS_p1,p2,p3, . . . pn'cr''lf']
This command is similar to the 'BCS_' command but, returns
modem analog parameters.
Where 'pn' is the last parameter returned.
Parameter
Number
Parameter Name
(Command Reference)
Description
1
2
3
4
5
Receive Signal Level
(ref. "RSL_" command).
Raw BER
(ref. "RBER_" command).
Corrected BER
(ref. "CBER_" command).
E
b
/N
0
(ref. "EBN0_" command).
Current Sweep Value
(ref. "CSV_" command).
p1 = xsnn.n, receive signal level in dBm.
p2 = xm.m
-ee
.
p3 = xm.m
-ee
.
p4 = xnn.n, E
b
/N
0
in dB.
p5 = snnnnn, sweep offset value in Hz.
Note: Parameters 2 through 5 are dependent on carrier acquisition, if the decoder is not locked empty data blocks are returned
(,,,,).