Comtech EF Data SNM-1001 - Manual (Page 83)

Remote Control Operation SNM-1001 Network Control Modem
A–24 Rev. 1
Bulk Consol
Status Command:
Response: <add/BCS_'cr'
>add/BCS_p1,p2,p3, . . . pn'cr''lf'] This command causes bulk modem status to be returned.
To reduce the length of the response, message parameter
data are returned without identifiers. However, parameter
identification can be determined by order of return. Each
status parameter is terminated with a ',' (comma) except for
the last parameter which has the standard message
termination sequence ('cr''lf']). Most of the data returned is
formatted the same way as the single command status
request (refer to the appropriate portions of this document in
preceding sections).
Where 'pn' is the last parameter returned.
Parameter
Number
Parameter Name
(Command Reference)
Description
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Modulator RF output
(ref. "RF_" command).
Modulator IF frequency
(ref. "MF_" command).
Modulator rate
(ref. "MR_" command).
Modulator preset 'A' assignment
(ref. "ARMA_" command).
Modulator preset 'B' assignment
(ref. "ARMB_" command).
Modulator preset 'C' assignment
(ref. "ARMC_" command).
Modulator preset 'D' assignment
(ref. "ARMD_" command).
Modulator preset 'V' assignment
(ref. "ARMV_" command).
Modulator power offset
(ref. "MPO_" command).
Modulator output power level
(ref. "MOP_" command).
Scrambler enable
(ref. "SE_" command).
Differential encoder enable
(ref. "DENC_" command).
Modulator type
(ref. "MT_" command).
Modulator encoder type
(ref. "MET_" command).
Transmit BPSK Data Ordering
(ref. "TDA_" command).
Carrier only mode ON/OFF.
p1 = n, where 'n' is '0' (off) or '1' (on).
p2 = nnn.nnnn, IF frequency in MHz.
p3 = nnnn_mmm.mmm, code rate/data rate in kbit/s.
p4 = nnnn_mmm.mmm, code rate/data rate in kbit/s.
p5 = nnnn_mmm.mmm, code rate/data rate in kbit/s.
p6 = nnnn_mmm.mmm, code rate/data rate in kbit/s.
p7 = nnnn_mmm.mmm, code rate/data rate in kbit/s.
p8 = nnnn_mmm.mmm, code rate/data rate in kbit/s.
p9 = snn.n, modulator power offset in dB.
p10 = snn.n, transmitter output power level in dBm.
p11 = n, where 'n' is '0' (off) or '1' (on).
p12 = n, where 'n' is '0' (off) or '1' (on).
p13 = n, where 'n' is '0' (EFD), '1' (INTL), '2' (CSC), '3'
(FDC), or 4 (SDM51).
p14 = n, where 'n' is '0' (SEQ) or '1' (VIT).
p15 = n, where 'n' is '0' (NRM) or '1' (INV).
p16 = n, where 'n' is '0' (off) or '1' (on).