Comtech EF Data SNM-1001 - Manual (Page 87)

Remote Control Operation SNM-1001 Network Control Modem
A–28 Rev. 1
Bulk Consol
Status
(Continued)
Parameter
Number
Parameter Name
(Command Reference)
Description
(Note 2)
(Note 2)
(Note 2)
(Note 2)
(Note 2)
(Note 2)
72
73
74
75
76
77
78
79
80
81
82
83
84
85
ASYNC Interface RD Signal
(ref. "IRD_" command).
ASYNC Interface RR Signal
(ref. "IRR_" command).
ASYNC Interface DM Signal
(ref. "IDM_" command).
ASYNC Interface CS Signal
(ref. "ICS_" command).
ASYNC Interface RT Signal
(ref. "IRT_" command).
ASYNC Interface ST Signal
(ref. "IST_" command).
Modulator Spectrum Rotation
(ref. "MSR_ command).
Demodulator Spectrum Rotation
(ref. "DSR_ command).
Reed-Solomon Encoder Enable
(ref "RSEN_ command).
Reed-Solomon Decoder Enable
(ref "RSDE_ command).
Reserved.
Reserved.
Reserved.
Reserved.
p72 = n, where 'n' is '0' (NORMAL) or '1' (INVERT).
p73 = n, where 'n' is '0' (NORMAL) or '1' (INVERT).
p74 = n, where 'n' is '0' (NORMAL) or '1' (INVERT).
p75 = n, where 'n' is '0' (NORMAL) or '1' (INVERT).
p76 = n, where 'n' is '0' (NORMAL) or '1' (INVERT).
p77 = n, where 'n' is '0' (NORMAL) or '1' (INVERT).
p78 = n, where 'n' is '0' (NORMAL) or '1' (INVERT).
p79 = n, where 'n' is '0' (NORMAL) or '1' (INVERT).
p80 = n, where 'n' is '0' (off) or '1' (on).
p81 = n, where 'n' is '0' (OFF) or '1' (CORR_OFF).
Notes:
1. Status only returned when ADPCM board is installed.
2. Status only returned when ASYNC board is installed.
3. Status only returned when ASYNC option is enabled.
4. For any parameter other than the last parameter that is not returned, a comma (",") will be returned.