Specifications, Pecifications – Comtech EF Data UT-4500 Series User Manual

Page 22

Advertising
background image

UT4500 Series Up Converter

MN/UT4500.IOM

Introduction

Revision 2

4

1.3 S

PECIFICATIONS

Note: Contact CEFD for specific requirements.

Table 1. UT-4505 C-Band Up Converter Specifications

Characteristic

Specification

Frequency Range
UT-4505
Conversion
Step

Size

Preset

Channels

Stability Over Time

Stability Over Temp

5845 to 6425 MHz
Dual, No Inversion
125 kHz standard, 1kHz optional
32 Frequencies and Gains
± 1 x 10

-9

/Day

± 1 x 10

-8

0 to 50°C

IF Input

Noise Figure

Level
Range


Impedance
Return

Loss


12 dB Maximum at 0 dB Attenuation

-35 dBm Typical
+20 dBm at 1 dB Compression
52 to 88 or 104 to 176 MHz, (optional 50 to 80

MHz or 100 to 180 MHz, see Note)

50 or 75

Ω

23 dB Min. with IO Module or Switch Module

RF Output

Output Level

Intermodulation

Carrier Mute

Non–carrier Spurious

Carrier Spurious

AM to PM

Return Loss

Impedance


+17 dBm at 1 dB Compression
-50 dBc @ 0 dBm Output SCL
-70 dBc
-80 dBm
-65 dBc @ 0 dBm Output
0.1°/dB at -5 dBm Out
20 dB Minimum with IO Module
18 dB Minimum with Switch Module
50

Ω

Transfer

Gain

Gain Adjust

Gain Stability

Ripple: 70 MHz IFCF


140 MHz IFCF


Slope
IF

Bandwidth


35 dB ± 2 dB
0 to 25 in 0.25 dB Steps
0.1 dB Steps Optional
± 0.25 dB/Day
± 0.25 dB (± 18 MHz), optional ± 20 MHz,

see Note )

0.75 dB (± 36 MHz), optional ± 40 MHz,

see Note )

0.05 dB/MHz
36 or 72 MHz, (optional 40 or 80 MHz, see Note)

External Ref.

Input 5 or 10 MHz @ +3dBm
Optional 10 MHz Rear Panel Reference Output

Advertising