Converter remote command summary, Onverter, Emote – Comtech EF Data UT-4500 Series User Manual
Page 96: Ommand, Ummary
UT4500 Series Up Converter
MN/UT4500.IOM
Remote Control
Revision 2
78
5.8 C
ONVERTER
R
EMOTE
C
OMMAND
S
UMMARY
Table 14. Remote Command Summary
Utility
Commands
Paragraph
Set Time
<DEV/TIM_hh:mm:ss'cr'
5.6.1.1
Set Date
<DEV/DAT_mm/dd/yy'cr'
5.6.1.2
Set Physical Address
<DEV/SPA_xxx'cr'
5.6.1.3
Set Baud Rate
<DEV/SBR_xxxx'cr'
5.6.1.4
Set LCD Contrast
<DEV/CON_xx'cr'
5.6.1.5
Set LCD Brightness
<DEV/LCD_xx'cr'
5.6.1.6
Set Reference Oscillator
<DEV/SRO_xxx'cr'
5.6.1.7
Set Converter Slope Adj.
<DEV/SSA_xxx'cr'
5.6.1.8
Retrieve Equipment Type
<DEV/RET_'cr'
5.6.1.9
Retrieve Firmware Information
<DEV/FRW_'cr'
5.6.1.10
Set Application ID Message
<DEV/AID_xxxxx...xxxxx'cr'
5.6.1.11
Configuration
Commands
Paragraph
Set Frequency
<DEV/FRE_xxxxx.xxx'cr' 5.6.2.1
Set Attenuation
<DEV/ATT_xx.xx'cr'
5.6.2.2
Select Cold Start Mode
<DEV/CLD_xxx'cr'
5.6.2.3
Mute/Unmute Converter
<DEV/MUT_xxx'cr'
5.6.2.4
Select Auto Fault Recovery Mode
<DEV/AFR_xxx'cr'
5.6.2.5
Program a Preset
<DEV/PGM_nn_xxxxx.xxx_yy.yy'cr' 5.6.2.6
Display All Presets
<DEV/DPS_'cr'
5.6.2.7
Clear a Preset
<DEV/CLR_nn'cr'
5.6.2.8
Select a Preset
<DEV/SEL_nn'cr'
5.6.2.9
Redundancy Mode
Commands
Paragraph
Select Redundancy ON/OFF
<DEV/RED_xxx’cr’
5.6.3.1
Configure Redundant Converter
<DEV/ICT_xx_yy’cr’
5.6.3.1
Select Auto/Manual Mode
<DEV/SAM_xx_y'cr'
5.6.3.2
Forced Backup Mode
<DEV/FBU_xx_y'cr'
5.6.3.3