Digital Alert Systems DASDEC-II MANUAL - Manual (Page 133)

Digital Alert Systems: DASDEC User Manual
127
Below the active alerts, the Alert Forwarding Action table supports multiple station status by displaying the
enabled and disabled actions per station. These actions can be changed at any time prior to forwarding in order
to affect the outcome of actions when an alert is forwarded to a specific station. Follow the Station name links to
the Setup > Decoder > Forwarding page, select the station, and then use the station configuration interface to
change the run time bindings for station alert forwarding.
After an alert is forwarded to a station, the stations button is replaced by the button.
Also, the message is displayed showing the time of forwarding to the station name. This message is an active
link to the Decoder > Forwarded Alerts web page. You can follow the link to that page and view the status of
the forwarded alert (see Chapter 5.3, Forwarded Alerts). The next screen shot shows the display for an active
decoded alert after forwarding to the second station.
The next screen shot show the changes to the alert display after using the other buttons. The screen
shot shows the active decoded alert status after forwarding to the first , second and third enabled station, and
after forwarding to all stations once (using the Forward Alert Once to All Stations button for forwarding to the
base station configuration). See the screen shots in the next chapter (5.3.1 Forwarded Alerts: Multistation Mode)
to view the corresponding Forwarded Alerts status display for these two examples.