Digital Alert Systems DASDEC-II MANUAL - Manual (Page 60)

54
Digital Alert Systems: DASDEC User Manual
Setup > Video/CG > Main Serial web page
3. FIPS and EAS Codes filter configuration
Use this section to edit Activating FIPS and EAS Codes. If activating FIPS and/or EAS codes are configured,
then the serial port CG will ONLY be activated during alert origination or forwarding when the alert contains
at least one of the FIPS codes and matches the EAS code.
When or is selected, the screen refreshes with a FIPS and EAS Codes filter
configuration section to allow editing. When finished editing codes, click. button to
return to the original web page.
REMEMBER to click to make any changes to this page apply.
4.7.2 USB Serial 1 through 4
The USB Serial sub-pages have the same organization as the Main Serial port page and operate in the same
way. Each page corresponds to a different physical serial port.
These ports are supported using the Serial Gear CS-42042 USB to 4 Port RS232 Adapter. Other adapters may
work, but they must be based on the FTDI chipset. As with the Main Serial Port, make sure that the proper cable