Fluke Biomedical INCU Incubator Analyzer - Manual (Page 23)

Incubator Analyzer
Connecting INCU
2-3
Connecting INCU
AC-DC Battery Charger Connection
The INCU can operate either on its internal battery or with AC power.
Connect the specified adapter to the INCU DC jack on the side of the unit.
Plug the opposite end into the AC power source. The universal charger can
be plugged into AC power sources ranging from 90 VAC to 240 VAC,
50/60 Hz. Use the charger to recharge the internal batteries when a “low
battery” warning is displayed. Regular charging of the battery will increase
its life.
Internal Battery
The system is equipped with a lead-acid battery, giving a maximum of 24
hours of operation. Use the AC Charger if recording parameters for longer
than 24-hour periods.
RS-232 Port
Connect the INCU RS 232 port to an available COM port on the PC using
the supplied 9-pin to 9-pin serial cable.
Warning: To reduce the risk of damage to the battery and to the INCU,
only use the specified Fluke Biomedical Charger, P/N 2213937,
AC-DC 8V 800 mA. Failure to do so will void the warranty.