Fluke Biomedical INCU Incubator Analyzer - Manual (Page 4)

INCU
Operators Manual
iv
Hazard Warnings
☛
Warning! Power Rating. The INCU mains power input must be connected using an
external power supply that provides voltage and current within the specified rating for
the system.
☛ Warning! Internal Voltage. Always turn off the power switch and unplug the power
cord before cleaning the outer surface of the INCU.
☛ Warning! Liquids. Avoid spilling liquids on the analyzer; fluid seepage into internal
components creates a potential shock hazard. Do not operate the instrument if
internal components are exposed to fluid.
☛ Warning! “Do not use in the presence of oxygen”. The Air Flow sensor is hot wire
technology and is a source of combustion if used in the presence of oxygen within
the incubator. Use the INCU only in ambient oxygen conditions.
☛
Warning! “Use only approved battery charger." The INCU contains a lead-acid
rechargeable battery. Use only the approved charger with proper voltage and current
ratings; otherwise, damage to the unit may result.
Precautions
The following precautions are provided to help you avoid damaging the system:
☛
Caution: Service. Authorized service personnel should service the INCU. Only
qualified technical personnel should perform troubleshooting and service procedures
on internal components.
☛ Caution: Environmental Conditions. Do not expose the system to temperature
extremes. Ambient temperatures should remain between 18°C to 40°C. System
performance may be adversely affected if temperatures fluctuate above or below this
range.
☛ Caution: Do NOT Immerse. Clean only with a mild detergent, and gently wipe down
with a clean, lint-free cloth.
☛
Caution: Electromagnetic radiation may affect the noise measurement.