FSR PATHFINDER Covers 12X8 THROUGH 32X32 - Manual (Page 26)

26 Pathfi nder Matrix
OUTPUT SETUP MENU PAGE
There are three differences between the input and output setup screens. One is that on the input
screen the user will be able to adjust the audio input trim. The second difference between an RGB
input and RGB output is the ability to enable or disable the RGB delay on the RGB output. The
third difference is the ability to enable and set sync equalization. Below is a screen for output 1.
The method of setting the output type works exactly the same as the input type setup except that the
message changes from input to output. The user can either choose an output directly using one of the
output buttons or use the UP, DOWN, and SELECT buttons to choose the output.
ESCAPE
SELECT
OUTPUT SETUP
OUTPUT NUMBER >
VIDEO TYPE
RGB DELAY
SYNC EQU
CABLE LENGTH
01
NATIVE
OFF
OFF
0
SAVE
RGB DELAY
RGB DELAY is used so that the display can sync up to the new sources' sync signals before
switching in the new source video. RGB DELAY is only for the RGB matrix and can be set as ON or
OFF (will not appear on the display when in split mode or on non-RGB models).
SYNC EQU
SYNC EQU is a feature designed to restore sync rise and fall time to compensate for losses in sync
levels over long cable runs. There are three settings: OFF, ON, or AUTO. When set to AUTO, sync
equalization will automatically turn on when CABLE LENGTH setting is set to 50' or more (will not
appear on the display when in split mode or on non-RGB models)
CABLE LENGTH (Output)
CABLE LENGTH gives the user the ability to compensate for the length of cable from the
Pathfi nder Matrix to the display. The settings are from 0 to 150 feet in increments of 10 feet. Zero
feet is off. The user presses the up and down buttons to select the length and presses the SELECT
button.
NOTE: A fi nal phase adjustment of the display should be performed after cable EQ
adjustments are completed to optimize the image quality