Using the cut charts, Estimated kerf-width compensation, Using the cut charts ‑2 – Hypertherm HRT User Manual
Page 38: Estimated kerf‑width compensation ‑2
Advertising
OPERATION
3-2
Duramax Retrofit Torch
Operator Manual
Using the cut charts
The following sections provide cut charts for each set of mechanized consumables. A consumable
diagram with part numbers precedes each section.
The arc voltage increases as the consumables wear and the voltage setting should be increased to
maintain the correct Torch‑to‑Work Distance.
Note:
Hypertherm collected the data under laboratory test conditions using new
consumables.
Estimated kerf-width compensation
The widths in the tables on the following two pages are for reference. The data is obtained with
the “Best Quality” settings. Differences between installations and material composition may cause
actual results to vary from those shown in the tables.
Advertising