Start a cut from the edge of the workpiece, Start a cut from the edge of the workpiece ‑44 – Hypertherm HRT User Manual
Page 80
Advertising
OPERATION
3-44
Duramax Retrofit Torch
Operator Manual
Start a cut from the edge of the workpiece
1. With the work clamp attached to
the workpiece, hold the torch nozzle
perpendicular (90°) to the edge of the
workpiece.
2. Press the torch’s trigger to start the arc.
Pause at the edge until the arc has cut
completely through the workpiece.
3. Drag the torch tip lightly across the
workpiece to proceed with the cut.
Maintain a steady, even pace.
Advertising