Datalogic Scanning DS6400 - Manual (Page 23)

INSTALLATION
2
2 INSTALLATION
To install the system follow the given procedure:
• Select the mounting location for DS6400;
• Mount the DS6400 scanner;
• Position the scanner with respect of the barcode;
• Proceed with system electrical connection;
• Install the Genius™ program on the PC and configure the scanner;
• Set the Flash™ dynamic focus by means of the Genius™ software tool.
WARNING
When installing several scanners, take care to position them correctly so
that no laser beam enters the reading window perpendicularly and at the
same level of the output beam of the other scanners. This condition could
occur more frequently for side mounted applications. If these precautions
are not followed, it may occur that the laser of the blinded scanner starts
blinking due to an internal circuit which temporarily turns the laser off
when detecting a power anomaly. To resolve this problem, it is sufficient
to slightly change the inclination and position of one of the two scanners
involved.
Refer to the Reference Documentation for details on connecting
NOTE
your
DS6400 reader to other devices in the system (i.e. C-BOX 100, etc ).
2.1 PACKAGE CONTENTS
Verify that the DS6400 reader and all the parts suppl
intact when opening the packaging; the list of parts inc
ied with the equipment are present and
ludes:
barcode test chart
• DS6400 configuration CD-ROM
• Mounting bracket and screws
• DS6400 reader
• Installation Quick Reference +
Figure 6 - DS6400 Package Contents
7