Typical layouts, Point-to-point, Er 2.7 for reference – Datalogic Scanning DS6400 User Manual

Page 52: Ut (refer to par. 2.7)

Advertising
background image

DS6400

2

ATTENTION

If using the “45° Skew” installation, the scanner reading performance is
not guaranteed to match that measured for the standard installation with
Skew angle between 10° - 20° (see reading diagrams in par. 4.4.1).


The ST-210 mounting bracket is an accessor

NOTE

y of the DS6400 standard

model available in the US-60 kit (890001020).


2.7 TYPICAL LAYOUTS


The DS6400 scanners can be connected in a variety of layouts depending on the number of

everal power supplies are available to power the reading stations. Photoelectric sensors

rs (see par. 3.2 for details).

he accessories and cables indicated in the following figures are Datalogic products. We

the correct system functioning.

rface. The Main interface can be selected for RS232 or RS485 full-duplex

communications.
Two different layouts are available according to the DS6400 reader model used for the
connection.

scanners used and the required complexity of the reading station. These layouts range from
Single Stand Alone to Complex Lonworks Networks.

S
used as code presence sensors and optical encoders to signal conveyor speed are also
available accessories.

The following typical layouts refer to the system hardware configurations, but they also
require the correct setup of the software configuration paramete

T
suggest their use to guarantee

2.7.1 Point-to-Point


Using a Point-to-Point layout, the data is transmitted on the Main interface as well as on the
Auxiliary inte

36

Advertising