Datalogic Scanning DS6400 - Manual (Page 24)

DS6400
2
2.2 MECHANICAL MOUNTING
2.2.1 Mounting the Scanner
The DS6400 reader can be positioned and installed in the best way possible as a result of
the Step-a-Head™ feature. Thanks to the separation between Head and Base, you can
modify the orientation of the decoder base, and therefore display-keypad and connector
panels, while keeping the optic head in the correct reading position. The reading head and
the decoder base can be rotated independently from each other allowing the installation even
in the most critical locations.
Head Screws
Fixing Screw (4)
Figure 7 - Step-A-Head™ Feature
. detach the head from the base by unscrewing the four fixing screws;
. rotate the head in the desired position;
loosen but don't remove the two screws on top of the head;
4. affix the head onto the base carefully aligning the four fixing screws and progressively
tightening them about half-way;
5. completely tighten the two screws on top of the head;
6. completely tighten the four fixing screws.
To rotate the head follow the given procedure:
1
2
3.
8