Datalogic Scanning DS6400 - Manual (Page 8)

The identification label is applied onto the bottom part of the scanner (Figure A, 2):
N2468
DATALOGIC S.p.A. Via Candini, 2
40012 LIPPO DI CALDERARA DI RENO (BO) ITALY
MANUFACTURED VOLT
Amp.
JANUARY 2002 15-30 DC 1.5-0.7
MODEL No.
SERIAL No.
This product conforms to the applicable requirements
of 21CFR 1040 at the date of manufacture.
Device Identification Label
The laser diode used in this device is classified as a Class 3B laser product according to
EN60825-1 regulations and as a Class IIIb laser product according to CDRH regulations. Any
violation of the optic parts in particular can cause radiation up to the maximum level of the
laser diode (35 mW at 630~680 nm).
POWER SUPPLY
- This product is intended to be installed by Qualified Personnel only.
- All DS6400 Models:
This device is intended to be supplied by a UL Listed Power Unit marked “Class 2” or LPS
power source which supplies power directly to the scanner via the 25/26-pin connector.
CE COMPLIANCE
Warning:
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
WEEE COMPLIANCE
oduct marked with the crossed out wheeled wastebin must be disposed of
Disposin
therwise could
you with the product in question
lt the dedicated section at the website www.automation.datalogic.com.
ENGLISH
Information for the user in accordance with the European Commission Directive 2002/96/EC
t the end of its useful life, the pr A
separately from urban waste.
g of the product according to this Directive:
avoids potentially negative conse • quences to the environment and human health which o
be caused by incorrect disposal
• enables the recovery of materials to obtain a significant savings of energy and resources.
or more detailed information about disposal, contact the supplier that provided F
or consu
viii