Marantz SR7007 - Manual (Page 117)

114
Tone
Default settings are underlined.
Adjust the tonal quality of the sound.
Setting items Setting details
Tone Control
Set the tone control function
to “On” and “Off”. On : Allow tone adjustment (bass, treble).
Off : Playback without tone adjustment.
“Tone Control” can be set when “Dynamic EQ” ( vpage 117 ) is set
to “Off”.
NOTE
• “Tone Control” settings are not reflected to ZONE2 and ZONE3.
• The tone cannot be adjusted in the “DIRECT” or “PURE DIRECT” mode.
Bass
Adjust bass. –6dB – +6dB (0dB)
“Bass” can be set when the menu “Tone Control” setting is “On”.
Treble
Adjust treble. –6dB – +6dB (0dB)
“Treble” can be set when the menu “Tone Control” setting is “On”.
Dialogue Level
Default settings are underlined.
Sets the output level to clarify the dialogue output from the center channel.
Setting items Setting details
Dialogue –12.0dB – +12.0dB (0dB)
Audio
Setting items Setting details
Center Width
Distributes the dialogue
output from the center
channel to left and right
channels and widens the
sound image in the front.
You can set this when the
sound mode is Dolby PL
gx
in the “Music” mode.
0 – 7 (3)
The smaller the value, the more dialogue is concentrated on the center
channel. The larger the value, the more dialogue is distributed to front
left and right channels, and the more the sound image widens in the
front.
Height Gain
Control the front height
channel volume. Low : Reduce the front height channel volume.
Normal : Front height channel sound is output with standard sound
volume.
High : Increase the front height channel volume.
NOTE
“Height Gain” is displayed for the following settings.
• When “Assign Mode” (
vpage 131 ) is set to “Main Only”.
• When the “Speaker Config.” – “Front Height” setting ( vpage 132 ) is
set other than to “None”.
• When sound mode is “PL gz” or the PLgz decoder is used.
Speaker Select
Make settings for the
speakers outputting sound
when playing back in original
surround mode. Surround Back : Sound is output from the surround back speakers.
Height : Sound is output from the front height speakers.
Wide : Sound is output from the front wide speakers.
Off : Sound is not output from the surround back speakers, front wide
speakers and front height speakers.
NOTE
Only speakers that are set to something other than “None” in “Speaker
Config.” (
vpage 131 ) can be selected.
Set Defaults
The “Surround Parameter”
settings are returned to the
default settings. Yes : Reset to the defaults.
No : Do not reset to the defaults.
When you select “Set Defaults” and press
ENTER , the “Reset to the default values?”
prompt is displayed. Select either “Yes” or
“No”, and press
ENTER .
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion
DVD