Marantz SR7007 - Manual (Page 149)

146
Registering preset codes
Check the registered preset code
1 Press and hold the input source
select buttons for the appliance
to control, and press SET until
indicator blinks twice.
The back light flashes.
2
Press INFO .
The indicator blinks twice, after which
the set code is shown for 3 seconds in
the remote control display.
n Remote control operation modes
By default, the input source select buttons on the remote control perform only the input source select operation. To operate an external
device with this remote control, set the preset code in “List of preset codes” (
vpage 183 ) for the device you want to register to each
input source select button.
For how to set preset codes to buttons, see “Registering preset codes” (
vpage 145 ).
If you register preset codes on this remote control, the input source select buttons on the remote control can perform the following two
functions.
q The function to switch input sources on this unit (AVR operation mode)
w The function to make this remote control switch to the mode in which you can operate the device registered to the button (External
device operation mode)
n How to switch operation modes
Press the input source
select button.
w External device
operation mode z2
Press AVR .
q AVR operation
mode z1
Input source
select buttons
z1 The mode in which you can operate this unit.
z2 If you press one of these buttons , the input source on this unit changes and the remote control switches
to the mode in which you can operate the external device registered to that button.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion
DVD