Marantz SR7007 - Manual (Page 154)

151
Operating learn function
• If the AV device is not a marantz device, or if the device does not
operate even when the preset code is registered, use the learning
function. Remote codes for different devices can be remembered
for use by the marantz remote control included with this device.
• This remote control unit is capable of learning around 160 codes.
Remembering remote control codes from
other devices
1 Place the marantz remote control and remote control
from the other device approximately 5 cm apart,
with the remote control signal transmission sections
facing each other.
5 cm
2
Press and hold SET until the LEARN indicator
blinks.
3 Press input source select buttons
to select the input source.
The input source is shown in the remote
control display.
NOTE
Before using the learning function, register
a preset code (
vpage 145 “Registering
preset codes”) for a mode other than AVR
preset (
vpage 147 ) to each input source
switch button.
4 Select the button to be learned.
LEARN indicator lights up.
5 Press and hold the button that you want to register
on the other remote control until “OK” is displayed
on the marantz remote control display.
• If “NG” is shown on the remote control display, perform step 5
again. If “NG” is shown again on the remote control display, the
remote control may not be able to learn the code correctly. In this
case, use the specialized remote control for the device.
• If the remote control memory becomes full, “FULL” is shown
on the remote control display. If you want to learn the code, you
should erase other learned button.
6 Repeat steps 4 and 5 to learn other buttons for the
same input source.
7 Repeat steps 3 to 6 to learn other input sources.
8 When programming of the remote control unit is
completed, press SET .
The LEARN indicator turns off, and the remote control unit exits
learn mode.
• There are some remote control units that cannot be programmed,
or even if they can be programmed, they may not operate correctly.
If this happens, use the remote control unit supplied with the AV
equipment to operate it.
• The operations of the programmed buttons override the preset
memory. If you do not require the programmed buttons, erase
the stored remote control codes to return to the initial settings
(
vpage 152 “Delete saved remote control codes”).
• The number of buttons that can be stored varies depending on the
remote control unit used. If you have stored the maximum number
of buttons allowed for the remote control unit, “FULL” appears on
its display.
NOTE
• The learning function is unavailable for all ZONE SELECT , SET , AVR ,
ON/STANDBY X , VOLUME df , FAVORITE STATION , SOUND
MODE and input source select buttons in any mode.
• While in the AVR operation mode, the learning function is unavailable.
• The learning procedure does not operate correctly if the batteries
have become worn.
• If no buttons are pressed for approximately 1 minutes while in the
LEARN mode, the remote control unit automatically exits from the
LEARN mode.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion
DVD