Marantz SR7007 - Manual (Page 36)

33
Set up speakers (Audyssey® Setup)
14
Select “Store” and then press ENTER .
Save the measurement results.
Audyssey Setup
Now storing...Please wait.
50%
Audyssey Setup
Distances
Speaker Config.
Levels
Crossovers
Store
Check processing results. To proceed, press “Store”.
• Saving the results requires about 10 seconds.
• During saving of measurements results, “Now storing...Please
wait.” is displayed. When saving is completed, “Storing complete.
Audyssey® Setup is now finished. Please unplug microphone.” is
displayed.
NOTE
During saving of measurement results, be sure not to turn off the
power.
15 Unplug the setup microphone from the unit’s SETUP
MIC jack.
16 Set Audyssey Dynamic Volume®.
Audyssey Setup
Yes
No
You can set Dynamic Volume function, which automatically
adjusts volume level for all content.
Do you want to enable?
• This feature adjusts the output volume to the optimal level while
constantly monitoring the level of the audio input to the unit.
Optimal volume control is performed automatically without any
loss in the dynamism and clarity of the sound when, for example,
the volume suddenly increases for commercials shown during
television programs.
n When turning Dynamic Volume on
• Press u to select “Yes”, and then press ENTER .
The unit automatically enters “Medium” ( vpage 117 ) mode.
n When turning Dynamic Volume off
• Press i to select “No”, and then press ENTER .
NOTE
After performing Audyssey® Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey® Setup again.
Store Finish Check
13
Use ui to select the item you
want to check, and then press
ENTER .
Audyssey Setup
Distances
Speaker Config.
Levels
Crossovers
Store
Check processing results. To proceed, press “Store”.
• Subwoofers may measure a greater reported distance than
the actual distance due to added electrical delay common in
subwoofers.
• If you want to check another item, press BACK .
NOTE
• If the result differs from the actual connection status, or if “Caution!”
is displayed, see “Error messages” ( vpage 34 ). Then carry out
Audyssey® Setup again.
• If you change speaker positions or orientation, perform Audyssey®
Setup again to find the optimal equalizer settings.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
Basic v
ersion
DVD