Operating external devices with the remote control, Registering preset codes – Marantz SR7007 User Manual
Page 148
145
Registering preset codes
When preset codes are registered in the included remote control unit,
it can then be used to operate any devices you have, such as DVD
players or TVs made by different manufacturers.
n Buttons used for operating the devices
q
DEVICE
X
For switching power of each device on or off.
w
uio
p
,
ENTER
,
BACK
For menu operation of each device.
e
MENU
,
INFO
,
OPTION,
SETUP
For displaying the menu of each device.
r
3
,
1
,
2
,
8
,
9
,
6
,
7
t
Number button (
0
–
9
,
+10
)
y
CH/PAGE
df
u
TV
X
,
TV INPUT
For operating a TV
This button is enabled in any mode.
For details on operation with the remote control unit, see pages
NOTE
The preset code cannot be registered to
M-XP
,
TUNER
,
PHONO
,
iPod/USB
,
NETWORK
and
INTERNET RADIO
.
Registering preset codes
The following two methods can be used for registering the reset code.
q
Entering a 4-digit code
w
Scanning the code table
n Entering a 4-digit code
See the preset code list table for the code to be input.
1
Press and hold the input source
select buttons for the appliance
to control, and press
SET
until
indicator blinks twice.
The back light flashes.
NOTE
Note that the group numbers that can be
registered are predefined for each input
source select button (
).
2
Press the 4-digit code for the
appliance using
0 – 9
(code table
at the end of this manual).
When the settings are complete, “OK”
is shown in the remote control display.
NOTE
If “NG” is displayed in the remote control
display, repeat steps 1 and 2, and enter the
same code again.
By registering preset codes for external devices to the provided remote control, you can operate your TV and playback devices (such as Blu-ray Disc player and DVD player) with the remote control.
n Scanning the code table
1
Switch the power on of the device
for which you want to set the
preset code.
2
Press and hold the input source
select buttons for the appliance
to control, and press
SET
until
indicator blinks twice.
The back light flashes.
3
Aim the remote control at the
appliance and slowly alternate
between pressing
CH/PAGE
d
and
DEVICE
X
for the appliance.
The preset code is shown in the remote
control display.
4
Stop when the appliance turns
off.
5
Press
ENTER
once to lock in the
code.
• Some manufacturers use more than one type of remote control code.
Preset codes to change the number and verify correct operation.
• If the AV device is not a marantz device, or if the device does not
operate even when the preset code is registered, use the learning
function. Remote codes for different devices can be remembered
for use by the marantz remote control included with this device.
NOTE
Depending on the model and year of manufacture of your device,
some buttons may not operate.
Operating external devices with the remote control
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion
DVD