Marantz SR7007 - Manual (Page 136)

133
Speakers
Setting items Setting details
Distances
Set distance from listening
position to speakers.
Measure beforehand the
distance from the listening
position to each speaker. Unit : Set the unit of distance.
• Feet / Meters
Step : Set the minimum variable width of the distance.
• 1ft / 0.1ft
• 0.1m / 0.01m
Set Defaults : The “Distances” settings are returned to the default
settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
When you select “Set Defaults” and press
ENTER , the “Reset to the default values?”
prompt is displayed. Select either “Yes” or
“No”, and press
ENTER .
Front L / Front R / F. Height L / F. Height R / Center / Subwoofer /
Surround L / Surround R / Surr. Back L
z / Surr. Back R z / F. Wide L /
F. Wide R : Select speaker for distance setting.
z When the “Speaker Config.” – “Surr. Back” setting ( vpage 132 ) is
set to “1spkr”, “Surr. Back” is displayed.
• 0.0ft – 60.0ft / 0.00m – 18.00m : Set the distance.
• The speakers that can be selected differ depending on the “Amp Assign”
( vpage 131 ) and “Speaker Config.” ( vpage 131 ) settings.
• Default settings :
Front L / Front R / F. Height L / F. Height R / Center / Subwoofer / Front
Wide L / Front Wide R : 12.0 ft (3.60 m)
Surround L / Surround R / Surr. Back L / Surr. Back R : 10.0 ft (3.00 m)
• Set the difference in the distance between the speakers to less than
20.0 ft (6.00 m).
NOTE
Speakers set to “None” in “Speaker Config.” ( vpage 131 ) are not
displayed.
Setting items Setting details
Levels
Set the volume of the test
tone to be the same when it
is output from each speaker. Test Tone Start : Output test tone.
• Front L / F. Height L / Center / F. Height R / Front R / F. Wide R /
Surround R / Surr. Back R z / Surr. Back L z / Surround L /
F. Wide L / Subwoofer : Select speaker to output test tone.
z When the “Speaker Config.” – “Surr. Back” setting ( vpage 132 ) is
set to “1spkr”, “Surr. Back” is displayed.
• –12.0dB – +12.0dB (0.0dB) : Adjust the volume.
When “Levels” is adjusted, the adjusted values are set for all the sound
modes.
NOTE
• Speakers set to “None” in the “Speaker Config.” ( vpage 131 )
settings are not displayed.
• When a headphones jack is inserted in the PHONES jack of this unit, the
“Levels” is not displayed.
Set Defaults : The “Levels” settings are returned to the default settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
When you select “Set Defaults” and press
ENTER , the “Reset to the default values?”
prompt is displayed. Select either “Yes” or
“No”, and press
ENTER .
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion
DVD