Datalogic Scanning Pegaso - Manual (Page 16)

Configuring the Pegaso
2-2 Pegaso™ Industrial PDA with Windows ® CE
Backlight
Select Start > Settings > Control Panel > Backlight to open the Backlight control panel.
Brightness
1. On the Brightness tab (refer to Figure 2-1 ), use the slider to adjust the brightness
to the desired setting. You can also use the <UP> and <DOWN> arrow keys to adjust
this setting.
2. Auto Power-Save dims (rather than turning off ) the backlight after 15 seconds of
inactivity. This features does not change the behavior of the Auto-Off Settings.
(Refer to "Power Configuration" on page
2-20 ).
3. The ambient light sensor automatically adjusts the intensity of the backlight on
the display and keypad in response to changes in lighting conditions. Select the
check box to enable or disable this feature.
Figure 2-1. Backlight Control Panel & Brightness
Auto-Off
On the Auto-Off tab, enable the desired option checkbox and select the desired options
from the pull-down lists (refer to Figure 2-1 ).
Increasing backlight brightness can cause the battery pack to discharge at a faster rate.
The battery discharge rate slows with a decrease in backlight usage.