Datalogic Scanning Pegaso - Manual (Page 66)

Networks, Communications, and Connections
4-4 Pegaso™ Industrial PDA with Windows ® CE
• Double-click and open ActiveSync from the Host PC’s System Tray if it is not
already open.
• Remove the Pegaso from the dock and then reinsert it into the dock or discon-
nect the cable from the Host PC and reconnect it.
• Select File > Get Connected for ActiveSync to look for a mobile device.
• Go to File > Connection Settings and make sure that your Connection Settings
dialog show the same selections as that in Figure 4-5 below if you have a USB
connection. If you have a serial connection, select the correct COM port from
the pull-down list.
Figure 4-5. Connection Settings
6. You have completed setting up ActiveSync. Proceed to "Installing the USB
Driver", below, to install the USB driver.
Installing the USB Driver
In order for the Host PC to communicate with the Pegaso, you must install the USB
driver file from the CD that came with the Pegaso, or download it from the Datalogic
website at
www.mobile.datalogic.com .
Microsoft ActiveSync must be installed on your computer before proceeding. See "Set-
ting up ActiveSync" on page
4-3 .
Important! Install the USB driver PRIOR to connecting the Pegaso to the host PC.