Datalogic Scanning Pegaso - Manual (Page 17)

Bluetooth Manager
Product Reference Guide 2-3
Activation
1. On the Activation tab, just tap the checkbox(es) to enable or disable them (refer to
Figure 2-1 ):
• Set the backlight to turn on automatically when any key is pressed or the touch-
screen is tapped, either while on battery or external power.
• Turn on the backlight when the trigger is pulled.
• Deselect Launch Control Panel from the Keyboard to turn off the ability to
open the Backlight control panel with a key sequence.
2. To exit and save your modifications, tap OK on the command bar, or press <Enter>
on the keypad.
Bluetooth Manager
Search for device
1. Select Start > Settings > Control Panel > Bluetooth Manager to open the Bluetooth con-
trol panel.
2. Search for the type of Device(s) you want to connect to by tapping Printer, Serial, or
All . The Pegaso will search for Bluetooth Devices within range.
3. If you attempt to set up a connection when the Bluetooth Radio is disabled, you
will receive a message reminding you that the radio is turned off, and asking you if
you want to turn it on. Tap
Yes if you need to enable the Bluetooth Radio.
Once searching is complete, Bluetooth Device Profiles will be displayed in the Discov-
ery tab. You can set up a connection to a device on the list, or clear it from the list by
tapping the
Clear button.
Using Auto-on while running from battery power will cause the battery pack to discharge
at a faster rate. The battery discharge rate decreases with a decrease in backlight usage.