Skutt KilnMaster Kilns Manufactured after March 1 2006 - Manual (Page 20)

20
p
rOgraMMing the
r
aMp
/h
Old
M
Ode
p
rOgraMing steps
s
tep
1
From Idle Mode, press ● RAMP/HOLD.
Display will show PROG alternating with a number between 1 and 6.
s
tep
2
Input the ● PROG Number of the Program you wish to create or run. (This is a number between 1 and
6 that you assign to a program which will be stored in permanent memory until it is replaced.) Press
ENTER
Display will show SEGS
s
tep
3
Input the total number of segments for your program. ● Press ENTER.
Display will show RA 1
s
tep
4
Input the first heating rate in degrees per hour. ● Press ENTER.
Display will show ˚F 1 (or ˚C 1 if using Celsius)
s
tep
5
Input the first temperature to reach. ● Press ENTER.
Display will show HLD 1.
s
tep
6
Input the amount of ● Hold Time in hours and minutes. Press ENTER.
Display will show ALRM if this the last segment you are entering, otherwise it will show RA 2.
s
tep
7
Repeat • steps 4 through 6 until all segments have been completed. The display will then flash ALRM
(Alarm) alternately with the current Alarm temperature. The default setting for no alarm is 9999. Enter
the desired alarm setting. Press ENTER
Display will briefly flash CPL
s
tep
8 – p
repare
v
enting
- (S
ee deScription on
p
age
15)
s
tep
9
The display will return to Idle mode. At this point the program is loaded and ready to start. Before •
pressing START, it is a good idea to press REVIEW to make sure the program was input correctly. Be
sure to check that the lid latch is secure on kilns that are equipped with lid lifters. Press START and
the program will begin firing.
Display will briefly show ON and then will show the internal temperature of the kiln chamber unless
a DELAY START has been programmed in which case it will begin counting down minutes from the
designated Delay time.
P
RogRamming