Skutt KilnMaster Kilns Manufactured after March 1 2006 - Manual (Page 4)

4
The minimum operating temperature is 33˚F (1˚C). •
The controller contains static-sensitive parts that may be damaged by static electricity. Use caution to avoid creating •
static that may damage the equipment. In areas where static electricity is common, or during dry times of the year
throughout the country, touch the kiln lid handle before touching the controller to discharge the static
installatiOn
As with all electrical products there is danger of electrical shock. Use only properly sized and rated copper wire •
when installing the power supply for your kiln. We recommend this work is done by a licensed electrician
Kilns should always be located in a dry place to prevent electrical shock and corrosion.
•
Follow all instruction for installation in this manual. Always observe fire, building and safety codes when installing any •
Skutt Product.
If there are fire sprinklers located in the kiln room make sure they are rated high enough so they will not be set off
•
when the kiln is at peak temperature. This should be tested with the kiln at peak temperature, the ventilation system
turned off and all doors and windows closed for maximum insurance.
We recommend having a fire extinguisher rated for electrical fires easily accessible near the kiln.
•
Skutt Ceramic Products Inc. will not assume liability for injury or damages caused by variations from the instructions •
put forth in this manual.
Kilns get hot. Observe all instructions to ensure proper clearances from flammable or temperature sensitive objects
•
and living things.
Ventilation is key to maintaining a healthy work environment and proper room temperature. Proper installation of a
•
Skutt Envirovent 2 will clear potentially harmful fumes from the room. To ensure proper room temperature is main-
tained consult a qualified HVAC professional.
The proper placement of thermocouples is crucial to the proper operation of all automatically controlled kilns. Check
•
all thermocouples for damage and correct placement. Thermocouples must protrude into the kiln chamber at least 1”
to ensure an accurate reading.
Only use the stand that is designated by Skutt Ceramic Products for your particular kiln model. Other stands may not
•
properly support the weight of your kiln, provide adequate clearance, and could pose a fire hazard.
The power cord is sized correctly to handle the power for your particular kiln. Never use an extension cord.
•
Make sure the power cord is routed in such a way as to not touch any portion of the kiln that gets hot. •
Be careful of pinch hazards when working on or assembling the kiln. •
Be sure to properly tension the springs on kilns equipped with lid lifters. •
M
aintenance
Always unplug the kiln before performing any repairs or general maintenance. If your kiln is wired direct, turn off the •
breaker.
Use only Skutt replacement parts. Improperly sourced parts may pose a hazard to you and your kiln and void your
•
warranty.
Never modify your kiln without first consulting Skutt. Improper modifications may pose a hazard to you and your
•
kiln and void your warranty.. Items such as alternative thermocouples, controllers, kiln coatings may ruin your kiln if
improperly installed or applied.
Replace any electrical components that are discolored ,brittle, or corroded.
•
Inspect all stainless steel bands to ensure they are tight. If they are loose, tighten them as much as possible to prevent •
the band from slipping or flexing.
s
afety