Skutt KilnMaster Kilns Manufactured after March 1 2006 - Manual (Page 51)

51
s
tep
4
Remove the thermocouple wires from the thermocouple terminal strip on the baffle. ●
They are attached with slide on connectors and should be pulled straight off.
Pulling at an angle can damage the connector.
s
tep
5
Lift the box up and set it aside. ●
Unfasten draw pull catches and lift sections apart using the handles ●
t
O reasseMBle
kM 1627
s
tep
1
Stack the sections in original sequence and secure the draw pull catches. ●
s
tep
2
Place the control box on its hinges. ●
s
tep
3
Reattach the feeder wires to their corresponding block. ●
Make sure the connection is tight to avoid electrical problems. ●
s
tep
4
Reattach the thermocouple wires in correct order. ●
s
tep
5
Reattach the screws which secure the control box to the kiln jacket. ●
KM 1627
Section Element Type Position
Upper Top/Bottom 1
Top/Bottom 2
Intermediate 3
Intermediate 4
Master Center 5
Center 6
Center 7
Center 8
Lower Intermediate 9
Intermediate 10
Top/Bottom 11
Top/Bottom 12
a
PPendiCes