Skutt KilnMaster Kilns Manufactured after March 1 2006 - Manual (Page 30)

30
m
enu
f
eatuRes
2key (2 k
eys tO
s
tart
k
iln
)
●
The “2KEY” feature allows you to set the controller so it takes two key presses to start the kiln. This helps
protect against accidentally starting the kiln. When activated it will be necessary to press START then
ENTER to start the program. To activate this feature access the “2KEY” setting through the “CNFG” menu,
use the “1” key to toggle the setting to ON and Press ENTER. Now when you press START to begin the
program you will see on the display. At this point Press ENTER to begin the program.
dTCT • (Detect Current Sensor Rating)
This feature indicates the maximum amperage rating for the current sensor installed in your kiln. The
current sensor is the hardware installed in your kiln which allows the controller to read the current from the
outputs. This feature should not be modified without consulting a Skutt technician. Changing this setting will
alter how the board interprets the current signal and will cause the board to produce erroneous current
readings.
rset (r
eset
t
O
F
actOry
s
ettings
) ●
Sometimes it is difficult to diagnose a kiln problem when factory settings have been modified. To reset
the factory settings access the “RSET” setting through the “CNFG” menu and Press ENTER. The following
settings will be restored.
Error codes on ●
TC offset set to zero ●
(OTHER)
The features contained in this menu heading are accessible only through direct contact with a
Skutt technician. If you change from a Type S thermocouple to a Type K thermocouple or vice-a-versa you will need
to change a feature setting in this menu section.
- - - -
- - - -