Skutt KilnMaster Kilns Manufactured after March 1 2006 - Manual (Page 50)

50
a
ppendix
7 —
s
etup fOr the
KM 1627
The 1627 will be packed in three separate boxes which will
include the following:
B
Ox
1
KM1627 ●
B
Ox
2
3 Piece Fiber Slab Insert ●
12 — 2 inch (2.54 centimeter) Posts ●
B
Ox
3
2 Piece Kiln Stand ●
6 Peep Plugs ●
“Goodie Bag” ●
Operating Manual ●
Warranty Card ●
12 Plastic Stand Feet ●
Lid Prop ●
s
et
u
p
Follow the general instructions on kiln setup in the Set Up
section of this manual. There are three main differences that should be noted when setting up the KM1627:
Due to the weight of the KM1627 you will want to separate the kiln into sections when you set it up. ●
The KM1627 has two stands that fit together for greater support. Place the stands flush together. ●
The KM1627 includes a three piece rigid fiber liner that fits inside the bottom section on top of the slab. ●
There are holes cast in the liner which hold the 2 inch (2.54 centimeter) ceramic posts. Carefully lay the
fiber insert on top of the slab after the first section is placed in position and insert the posts.
c
autiOn
–
Before disassembling any Oval kiln, be sure to turn off power to the kiln by throwing the circuit
breaker or removing the fuse on its circuit. Do not restore power to the kiln until it is fully reassembled.
D
isasseMBling the
kM1627
s
tep
1
Remove the screws from the left side of the control box. ●
s
tep
2
Swing open the control box open. ●
s
tep
3
Remove the screws holding the feeder wires to the two pole blocks on the heat baffle. ●
There are three sets with two feeder wires going into each set.
a
PPendiCes