Super Systems 9205 Series - Manual (Page 103)

Series 9205 Operations Manual Rev A 102
CO Factor
Displays the current CO Factor. When selected, this setting allows you to set the current CO Factor. The
range is 0 - 1000. NOTE: A CO Factor of 200 represents approximately 20.0% CO in the furnace.
H Factor
Displays the current H Factor. When selected, this setting allows you to set the current H Factor. The range
is 0 - 1000. NOTE: An H Factor of 400 represents approximately 40.0 % H
2
in the furnace.
Default Wait Limits
The 9205 controller uses default wait limits in
conjunction with recipe programs using the wait, wait
up, or wait down feature, or guaranteed soaks,
atmospheres, etc. The wait limits are in place to help
make sure a recipe will not continue to the next step
until the process variable is within the specified range.
The wait limits are both plus and minus the value of the
setpoint specified in the recipe.
Temp Wait Limit
This is the specific wait limit for the temperature PV. The range is: 0 to 4000.
Atm Wait Limit
This is the specific wait limit for the atmosphere PV.
Range is 0-40