Super Systems 9205 Series - Manual (Page 184)

xSeries 9205 Operations Manual Rev A 183
Appendix E – Factory Default Settings for the 9205 Controller
Field Factory Default Value
Revision
Revision 2.61
Probe Setup
Burnoff Time (sec) 90
Burnoff Rec. Wait Time (sec) 120
Burnoff Interval (min) 720
Burnoff Minimum Millivolts 800
Burnoff Maximum Temperature 2000
Digital IN 4 Assignment Event
Burnoff Minimum Millivolts Alarm SP 800
Burnoff Maximum Temperature Rise Limit 75
PID Loop 1 Setup
Prop Band (0 for On/Off) 20.0
Reset 0.10
Rate 0.00
Mode Dual Reverse
Integral Preset 0
Cycle Time 16
Setpoint Change Limit OFF
Low Limit -100
High Limit 100
0 set point stops control Yes
IN1 high limit shuts down ctrl No
IN2 high limit shuts down ctrl No
IN3 high limit shuts down ctrl No
PID auto switch No
Switch Point PID 1->2 99.99
Switch Point PID 2->3 99.99
Setpoint Lower Limit -99.99
Setpoint Upper Limit 299.99
PV Source internal
Minimum Fwd On Time (sec) 0.00
Minimum Fwd Off Time (sec) 0.00
Minimum Rev On Time (sec) 0.00
Minimum Rev Off Time (sec) 0.00
Positive Output Accumulator 5941.4
Negative Output Accumulator 0.0
Overshoot Control Logic No
Ramp Detect Logic No
Ramp Overshoot Control Level 1 No
Ramp Overshoot Control Level 2 No