Teac DR-40 - Manual (Page 41)

TASCAM DR-40
41
Connecting monitors and headphones
To listen with headphones, connect them to the /LINE OUT
jack.
To listen with an external monitoring system (powered
monitor speakers or an amplifier and speakers), connect it to
the /LINE OUT jack.
Powered monitor speakers or
amplifer and speakers
Headphones
Using the built-in microphone
This unit’s built-in microphones can be adjusted, allowing the
angles of the microphones to be changed. You can choose
clear stereo sound or wide stereo sound according to the
recording source, situation, etc. by opening or closing the
microphone pair.
Setting the mics to record a wide stereo sound
(A-B position)
Spread the stereo microphone to the left and right. (A-B
position)
Set this way, the two microphones are spread widely left and
right, and recording is possible with a strong stereo field that
is good for music, for example.
If you open or close the microphone pair while using the built-
in stereo microphone and the left-right channels does not suit
the angle of the microphone, a pop-up message appears to
ask whether you want to swap the left-right channels of the
microphone. (See “Microphone position detection” on page
43.)
3 – Preparation