Thinklogical HDX80 Manual - Manual (Page 26)

Revision A December 2011 18
Warning! Minimum bend radius must be 1.5”. Be careful not to pinch the
fiber when using ties.
Installing Fiber into Input/Output Cards
Step 1: Grasp the LC connector of the fiber optic cable by the sides and remove the dust cap.
Warning! Laser in use! Do not look directly into the opening.
Step 2: Open the LC retractable and carefully insert the fiber connector into the SFP+ port until
it locks into place.
Removing Fiber from Input/Output Cards
Step 1: The LC connector has a locking feature that can be released by depressing the latch-
release tab located on the side of the connector. With the tab depressed, slowly remove the
cable by pulling the connector straight out of the SFP+ port.
Warning! Laser in use! Do not look directly into the opening.
Step 2: Immediately install a dust cap on the ferrule to protect the fiber tip.
Connecting to Thinklogical™ SDI Xtreme 3G+ Extenders
The HDX Routers are designed to work with the Thinklogical SDI Xtreme 3G+ product line as
well as ImageEvolution X3, SDI to HDMI Converter and extenders, and HDMI to SDI Converters
and extenders.
Connecting to the Receiver
The SDI Xtreme 3G+ Receiver serves as the Destination (theaters, editing suites, control
consoles, video walls, etc). Power can then be supplied to the unit. The Receiver then
connects to the HDX Router I/O ports using fiber (Multi-mode fiber for distances up to 1000m;
Single-mode fiber for distances beyond 1000m).