Thinklogical HDX80 Manual - Manual (Page 66)

Revision A December 2011 58
"Press to Record" button will cause the system to interrogate every port and save the settings to
a new .csv file in the setups/snapshots/ directory with the same name as the snapshot.
To change the name of a snapshot or delete it, select it from the pull-down list. Its name will
appear in the text input box next to "Change name here", as well as a "Delete This Snapshot"
button. To change the name, change the text in the input box. To delete it, click the "Delete"
button and then accept the action on the confirmation pop-up.
Existing Snapshots will appear as buttons and selecting one of these buttons will execute the
snapshot after an “Are you sure?” confirmation pop up.
Figure 42: Snapshots
STUDIO
The Studio page is an alternate view to the Connections tab. Connecting ports in the Studio
view is a different process and has additional options. (To add this page to the links please see
the Groups section.) This page is not designed for use as an administration page. To navigate
back to other pages use the back arrow in your browser.
To make a connection, select both a destination and a source (in any order). They will turn blue
when selected.
"TAKE" will cause any existing destinations for the selected source to be disconnected, and
then the chosen destination will be given the only connection for the chosen source, as well as
being connected to the serial control of the source (if present).
"(VIEW)" will not disturb any existing connections from the source, but the new destination will
not receive control of the source (if present). This is useful if a user wishes to monitor a source
without disturbing any existing users of that source.
The (VIEW) button is rendered with parenthesis to remind users that VIEW only gives them the
ability to see the source and not control it. Destination boxes with sources that are connected
using VIEW will show the source name in parenthesis meaning that the source can be seen but
not controlled. Only one destination will show the source name without parenthesis, and that is
the one with the serial control channel (if present).
NOTE: If no other destination is using the source at the time the (VIEW) button is
pressed, then the new destination will also get the back channel serial control (if
present).